N.C SERIES 30000

N.C. SOLENOID VALVES . - REFRIGERANT FLUIDS HCFC-HFC-HFO-HC

N.C SERIES 30000 N.C. SOLENOID VALVES . - REFRIGERANT FLUIDS HCFC-HFC-HFO-HC

Category: ODF & SAE CONNECTIONS

Ways: 2/2

Surface treatments applicable: no

Notes:


The 30000 series solenoid valves can be supplied in the following configurations:

  • Valve without coil
  • Complete valve with coil 
  • Complete valve with coil and connector

The ATEX certified version is supplied:
  • Complete with coil and Atex connector

Solenoid valves series  30000, 30100 and 30200 are are 2/2 ways normally closed. Depending on the model the operation principle is direct or servo-controlled with membrane. Connections are SAE FLARE or ODF ( copper pipes)
  •  HIGHLY ROBUST, the thickness of the sleeve obtained from AISI 303 stainless steel machined solid bar is greater than that of traditional tubes obtained from thin metal sheet 
  • 100% SAFE, approved IP67 UL“INTERNATIONAL PROTECTION” rating
  • 100% TESTED, each valve bears the date and serial number proving that it has passed the test and allowing traceability of the performance data measured during testing over time.
Solenoid valves 30000 series are designed for installation on commercial refrigeration systems on civil and industrial air conditioning plants that use the following refrigerant fluids belonging to Group 2, as defined in Article 13, chapter 1, Point (b) of Directive 2014/68/EU, with reference to EC Regulation No. 1272/2008. See page 19 for more information about refrigerant fluids compatible.
The main construction components of the solenoid valves of the 30000 series are:
  • Hot-forged brass body and cover EN12165-CW617N 
  • EN12735-1-Cu-DHP brass pipe for welding connection 
  • AISI 303 stainless steel sleeve 
  • Ferritic stainless steel for cores 
  • AISI 302 stainless steel spring 
  • Outside Neoprene seal (option available: HNBR for flammable fluids) 
  • PTFE seat sealing gasket 
  • Class H coil (180°C) 
  • Locking nut made of zinc-plated stainless steel 
  • Austenitic stainless steel for clamping screws between cover and body (A2-70)
Solenoid valves can be installed anywhere in the system provided that the cooling capacity of all different models is taken into account. The device must be installed ensuring that the refrigerant flows in the direction shown by the arrows on the valve body. All models of this series can be mounted in all positions except for the one with a coil turned downwards. Brazing of valves to weldable pipes must be carried out using an alloy with low melting point. To avoid damages, make sure the flame is not pointed to the body during pipe welding. Before connecting the device make sure the operating data shown on the coil correspond to those on the system. Please read enclosed leaflet before proceeding with the installation.
prova3
prova3
30000BHFP
30000BHFP
10000BHL
10000BHL
30000-13
30000-13
7000-CON
7000-CON
Connettore Atex
Connettore Atex
models
30000-F
30000-F
30000-T
30000-T
30100-F
30100-F
30100-T
30100-T
30200-F
30200-F
30200-T
30200-T