SERIES 43001

RECEIVERS FOR SPLIT AIR CONDITIONING FLUIDI REFRIGERANTI HCFC-HFC-HFO

SERIES 43001 RECEIVERS FOR SPLIT AIR CONDITIONING FLUIDI REFRIGERANTI HCFC-HFC-HFO

Category: ODF & SAE CONNECTIONS

Surface treatments applicable: no

Notes: 0

The receiver for split air conditioners is designed to withstand 1.43 times the PS according to the standards set by the Directive 2014/68 / UE. In addition, laboratory tests certify the resistance of the receiver to bursting pressure equal to 3xPS in accordaN.C.e with EN 378-2: 2016.
  • SECURE SEAL: guaranteed thanks to the presence of a double-OR between the body and the pin
  • NOT TAMPERABLE: When you open the tap completely, the pin cannot slip out, thanks to the edge-wrapping of the upper body
  • COMPACT: the whole maneuvering system is inside the body and the movement of the pin can be carried out with a simple Allen key
The stop valves for split conditioning systems in the series 43001 are designed to be in-stalled on refrigeration and air-conditioning system for domestic and industrial use. It’s possible to use them with all the refrigerant fluids of goup 2 of Art.13, Chapter 1, point B, of Euopean Directive 2014/68/EU, with reference to EC Regulation no. 1272/2008. Below i s a list of the main refrigerant gases that can be used:
  • HCFC
  • HFC
  • HFO and HFO/HFC blends
  • Some typical applications are:
  • Split air conditioners
  • Air-conditioning systems 
  • Chillers
  • Heat pumps
  • The main construction components of stop valves for split conditioning systems in the 43001 series are: 
  • Brass body EN12165 CW617N
  • Brass tap EN12165 CW617N
  • Brass spin EN 12164-CW614N
  • Neoprene sealing gasket 
 Stop valves serie 43001 should be fitted with thse components (separately sortable): 
  • Art. 31516 valve mechanism with external spring 
  • Art. 31516-A valve mechanism with internal spring
  • Art. 31516-B valve mechanism with exteranal spring and HNBR sealing gasket
  • Art. 31514 or 31515 cap for SAE threads.
Make sure the refrigeration/conditioning system is properly clean before installing the valve with a three-way screw plug. The presence of impurities could affect the sealing of the valve. Valve opening/closing is very easy: you only need to remove the protection cover and rotate the pin clockwise to close the valve and anti-clockwise to open it, using an Allen wrench. Then remount the protection cover. Braze welding between the pipes and the valve is performed by using heating. The presence of seals in the valve requires the fitter to pay particular attention in avoiding to direct the flame towards the valve body and sealing areas in general. We recommend protecting the valve body with a wet cloth during this operation. Before installing the valve, it is advisable to carefully read the instruction leaflet contained in each package.
models
43001
43001